A protection for the Anycubic Kossel V2 probe in case it crashes into the bed and a compatible holder to store it.

A simple but efficient shield for the Anycubic Kossel Z probe V2 to protect the switch if it hits the bed. This happened to me a few times when tinkering my printer.

With the protector, comes a compatible holder to store the probe when it's not in use. There is a vertical and an horizontal versions.

Protector and vertical holder don't require supports, horizontal holder do requires supports touching the build plate only.

Installation is straighforward: just remove the 4 screws under the probe, place the shield, replace the screws.

To install the holder you need a screw and a T-nut to attach it to the printer's frame. You can place it where you prefer. Note there are 2 models of older, one for the vertical frame, the other for the horizontal one. Pick the one you need depending where you want to place the holder.

The result:

This work is licensed under a Creative Commons 4.0 International License Attribution - Noncommercial - Share Alike

This model is free to download and use for a personal, non-commercial, use.

You can download it from my profiles:

• Printables : Anycubic Kossel Probe V2 Protector and Holder
• MakerWorld : Anycubic Kossel Probe V2 Protector and Holder
• Thingiverse : Anycubic Kossel Probe V2 Protector and Holder